Hey guys. I just bought an aero wing, which my car didn't come with from the factory, but I noticed the boot has three holes stamped which look like they would be for the wing? All the boots would've had that I assume. Is this where it bolts on? I'm deleting the middle pillar, so I'm not worried...
Hey guys, might be a silly question but i have a stock s15 atm, just wondering if i will be able to take the stock cat back exhaust off and fit a bolt on 3" straight to the stock cat?
just wanna know before i buy!
Hey guys, ive just bought a completely stock 15 and im looking to chuck an exhaust on it,
This may seem like a stupid question but if i buy a 3" bolt on cat back will it bolt straight onto the stock cat? Just dont wanna buy the exhaust if it wont,
Sent from my iPhone using...
Can someone please give me part numbers, even better a way to download fast?
S15 spec R 1999 manual
32mm Drive shaft nut
S13 handbrake anchor bolt, hex nut, washer
Pair needed, not sure if they are the same both sides
He fellow S-owners,
I'm busy getting a good Knock-Detection-System, building this:
Earmuffs with a air hose attached to the blok. Seems simple, and simple solution are the best! :D
Anyone tried this on a SR20DET? any good results...
S15 spec R stock suspension. Good working order £30 collected or £60 delivered.
Nice clean S15 spec R rear upper arm set. £20 collected or £40 delivered.
Bolt set not included, little freckles are just under seal overspray.
S14/S15 'baller bolt' rear bolt set with eccentric lockout, these...
These have kindly been lost for me while my car has been worked on, hoping someone has some spares laying around?
The ones highlighted there, I need 1 of each. Also I need one front seat mounting bolt.
Hey just curious. I own an s15 nzdm version, so the badge on the hood/bonnet says 'Nissan' I'm looking to change it to the JDM badge 'Lighting Bolt' will it be possible to do so? Im not sure whether the lighting bolt badge will fit onto the hood/bonnet as the nissan badge is much larger than the...
This genuine Project Mu magnetic drain bolt is awesome and gives you an extra 1000BHP when fitted!
Yours for only £15 Delivered.
Size = M12 x P1.25
Does not give you any BHP gains whatsoever, but cats do enjoy looking at Project Mu bling when sat underneath your car and are...
I have one of these bad boys for sale - http://www.nismo.co.jp/en/products/competition/lsd/gt_lsd.html
4.083 ratio, comes in casing for S-bodies, with ABS / Speedo sensor, 6 bolt flanges, and I'll throw in matching driveshafts from my S15 for free if needed.
£550 including postage, no offers.
Not sure how to explain it, but is the plastic bolt that slots into the front part of the wing and is what holds the corner of the bumper on. Pic below.
The tread is knackered (screw fell out) so need a new one but haven't a clue where to get one. Would Nissan be a good start, or are...
Besides the diff itself, what else is needed to bolt an R33 diff on?
Do I need full R33 driveshafts for the 5 bolt flange fitment or can I use the S15 shafts / stubs.
I recall reading that I'd need R33 stubs, shafts and some hub parts as the shaft length and splines are...
After a pair of 15mm bolt on spacers OR SLIP ON spacers actually, as i do have some extended studs i could fit.
They are for the front on the S15 as my 10j's are fouling the coilovers.
hit me a pm if you have some