boost guage not reading

[JameS15]

Guys just a quick one (i have searched but cant find a location! ) My factory boost guage has stopped working. Flicks up when the ignition and engine is switched on but just sits at 0 and wont move. Guessing its the pipe to the guage but i must be being thick as i cant seem to see it! :wack:

Where is it?

Would this cause any kind of boost leak if the pipe had split as its been feeling down on power lately and the guage had started reading low before the drift day (which seemed to kill it off ) or is it literally just a feed to the guage?

Cheers guys!!

 

[Nickichi]

it tees in right next to the battery/Fuse box

The sensor sits on the driver side strut were the arch is. little black box with a whiteish clip, just follow the pipe back to the tee

Im about 90% sure its that but i cant check atm

http://i173.photobucket.com/albums/w51/zaftadmin/S15/DSCF0681Sensor.jpg

 

[JameS15]

Cheers dude thanks for the pic! Will have a look after work tomorrow as its too dark now

 

[elmo-S15]

its the solenoid mate.. maybe its not working properly

 

[DeanS15]

i have a solenoid and gauge if you need for a few beer tokens