Fitting Boost Controller - HKS EVC

[Alex De Large]

Apologies for the proper noobish question but i'm trying to fit my HKS EVC, i'm having a problem wiring it up from the engine bay to the cabin.

Can anyone offer any advice as to where they slotted their cable through into the cabin.

If anyone can help, much appreciated!

 

[craig8585]

Take the drivers arch liner our and pop it through the big rubber grommet. Then it'll route into the drivers footwell

 

[Alex De Large]

Thank you very much man! You've been a big help.

I'll give it a whirl tomorrow once the rain has stopped.

 

[spoonman]

Another option. There's a grommet just the right of the clutch master cylinder about a inch in size which isn't used, this is looking from the drivers side of the engine bay, you may have to remove the plastic part of the dash that sits below the steering column to get to where it comes into the cabin.

 

[pegliobaglio]

As above either option works,I ran my boost gauge cabling through the grommet in the bulk head comes out just above the clutch pedal you don't need to remove and plastics and you can route the cabling from there a little easier than through the wing depending on where you plan to position your evc!

 

[Alex De Large]

Cheers everyone.

Managed to get it wired through the big grommet in the wheel arch as the one near the clutch was already taken.