Need pics of gear lever assembley and pics down into the gearbox.

[subzero]

its been a niggly problem ive had with my car for years, time to try fix it. im gonna remove the short shifter and just put back in a standard shifter.

i have a shifter and i think ive a circlip there too .

just want to see how the lever is held down in the box .

really appreciate any help here and pics if possible.

 

[S.K]

It is just held in with a circlip

Have a look here on page 11 for pics

https://workspaces.acrobat.com/?d=5YbeJQd3lTc9i60CC1r7rA

Hope this helps :thumbs:

 

[spoonman]

this in reverse

http://jull.net/s15-tech-guides/c-short-shifter

 

[subzero]

hmm ..... ive the same c's shifter ....

would i get circlips in any motor factors ?

 

[Krish]

hmm ..... ive the same c's shifter ....

would i get circlips in any motor factors ?

Make sure they are solid and not the multi-tools. I had real issues with them

 

[subzero]

right , figured out a few of my problems , the ring that spaces the shifter higher (to make a short shift) had two spacers , one from my new kit and one from the previous short shifter that was not sitting right .

going by the guide above, how do i fit the two circlips ?? there is a grove to take a circlip but one if too small and the other i just dont know how to get it down into the groove .... really bit long nose pliers ??

 

[subzero]

this clip goes into the groove ?? but how ?

[/img]