I don't have a picture to hand but the bit i am referring too is the plastic clip thing that sits inside the gear shift gaiter which then connects it to the centre console.
I'm planning on having some 3D printed at work very soon as mine is old and brittle and will blatantly break when i install my Yashio goodies, so my question is would anyone else be interested in one or several?
cost wise I'd say £1+ postage which would be probably no more than a 1st class stamp but will double check
****edit****
to save reading the whole post, cost is £3.50 plus £1 per ring, leave a message on the thread and I will PM payment details and add you to the list below:
Jaydej- POSTED
Phillll- POSTED
cap'n'crash- POSTED
Ismithmx- POSTED
Nath F- PM'd
Sammos13- COLLECTED
Slidder200- POSTED
ALS_jordan- POSTED
Cess- PAID- POSTED
Mitch- PAID- POSTED
1990_wayno- POSTED
Gaz 15- POSTED
Packham- POSTED
Shelb-PAID
Nemisis Guy- PAID
Seal123- PAID
I'm planning on having some 3D printed at work very soon as mine is old and brittle and will blatantly break when i install my Yashio goodies, so my question is would anyone else be interested in one or several?
cost wise I'd say £1+ postage which would be probably no more than a 1st class stamp but will double check
****edit****
to save reading the whole post, cost is £3.50 plus £1 per ring, leave a message on the thread and I will PM payment details and add you to the list below:
Jaydej- POSTED
Phillll- POSTED
cap'n'crash- POSTED
Ismithmx- POSTED
Nath F- PM'd
Sammos13- COLLECTED
Slidder200- POSTED
ALS_jordan- POSTED
Cess- PAID- POSTED
Mitch- PAID- POSTED
1990_wayno- POSTED
Gaz 15- POSTED
Packham- POSTED
Shelb-PAID
Nemisis Guy- PAID
Seal123- PAID
Last edited: