What's new

osgiken clutch seems slipped but not

Sair

Joined
28 December 2010
Messages
139
Reaction score
0
Points
16
Location
Northampton
Country
i just change my s15 std clutch to os giken twin plate . the giken clutch is actually bit used and took out from driven s15 but i cleaned the minor rust on it except plates. now the issue is that my car is not gripping ( high rpm but no speed above then 50kmh) it seems like clutch is slipped but no smell because of almunium plates..

several advices have been given to me but not satisfied im much prefer to authentic and professionals
1. drive the car around 50 to 60 km it mite grip
2. take out the clutch and clean the bit rust on plate it and put it back again
3.take out the clutch set it. teeth (grind) by lathe machine guys
4. check it isn't push type or pull .. or it mite be adopter of push type with the plate..
 
Joined
9 September 2009
Messages
1,864
Reaction score
0
Points
0
Location
New Zealand
Country
have you adjusted the pedal position? if not it might be holding your clutch out slightly
 

Sair

Joined
28 December 2010
Messages
139
Reaction score
0
Points
16
Location
Northampton
Country
Did it come with the flywheel and flywheel bolts?

and is it the S15 6 speed specific one?
yes it comes with the flywheel and bolts and it is out from a 6 speed s15 .. secondly is there any possiblity of pressure setting of used clutch...
 
Joined
30 November 2007
Messages
2,152
Reaction score
0
Points
0
Location
Sunny Tweed Heads
As Spoonman said have you adjusted the pre load on the peddle, being a twin plate compaired to your old single plate.
 
Top