Hi folks, looking to completely rebuild my S15 following a recent accident.
Anyone have an S15 shell up for grabs? Doesn’t matter if spec r or s as I’ll be seam welding it. Can cope with minor dents but must be straight.
Once metal work done will be performing a bare metal respray in...
Anyone interested in a boot lid? It's been shot blasted back to bare metal. So has surface rust but nothing major. Has indentations across the top surface which were previously filled but beyond my diy expertise to fix.
Has holes for the oem spoiler.
Would suit a drift/track car I would say...
Need some feedback here guys as my turbo is coming out for all new gaskets and braided lines at the weekend.should i just get some OEM Lock tabs or are those driftworks metal lock nuts a better idea the only mods done to engine will be elbow and downpipe so more or less standard set up.Im...
Looking to get a metal intake pipe for my S15, noticed a few people here using them.
Am I right in assuming most people just get them fabricated? Or is there an actual supplier?
Any help would be great,
Just replaced both front wheel bearings/hubs and need to replace the 32mm hub nuts.
Nissan said it would be a 3 week wait! Anyone know where to pick some up? Also, the metal hub 'cap' that acts as a weather seal could do with renewing too if they are available
Has anyone ever taken the covers off their seats?
Mine are damp/ mouldy and I need to get them off.
So far it looks like a ballache!!!
All these metal clips look like a pain to get off and on again
Few s15 bits and bobs:
Swift 060's and 080's x 2 lowering springs €40 (think for s15 or levin cant remember)
Ripspeed Pedals with screws (NEW) €15
Blue wheel nuts (20pk with locking key) 1.25 x 12 thread €50 (to suit s15)
S15 Rear Lights as new (no scratches) €80
Idle Control Valve...
Right chaps, as some of you may know I have a little problem.
Fitted my Mani a few weeks ago, had a little water leak so removed it all and when I put it all back together the oil line ( block end) wouldn't tighten up it screws in but won't go tight if you get what I mean? Seems the thread in...
The method I used here caused no clips to snap, no plastics to melt, and generally, no damage AT ALL to the headlight unit. :)
First, preheat oven to 90'c and arrange the shelves so that you can squeeze your headlight in. I used tin foil to prevent tray imprints on my headlight, and also to...
Need a pair of front fenders. not in a major hurry as the rust has already put a hole through my current one, so it cant look much worse than it already does. hahaha.
METAL ONES ONLY please. I dont do fibreglass.
pewter would be nice, but i'll settle with any colour.
Right chap's I have done the search and only found a post about fitting HID'S to S15 headlights and people asking if it can de done.. Well I did it yesterday and took some pic's to help anyone who may want to do it themselves.
Pop revets, X2
Some strips of metal needs to be quite...
basically whenever i put my indicator on all the hazards flash and the alarm goes off. i also cant set the alarm or use the remote i have to lock and unlock the car wiht the key. plus i cant use the normal standard key with the black box think at the top. i have to use the plain metal key...
Need someone with Nissan FAST to verify these part numbers with pictures please,
Basicaly, I am looking for some trim parts for my S15. Looking for the outer door trim that sits on the top of the metal...