elizium
⭐
- Joined
- 14 November 2005
- Messages
- 386
- Reaction score
- 0
- Points
- 16
- Location
- Moscow, Russian Federation
- Website
- www.mys15.org
Started the process of the manual conversion today - can't be bothered waiting for the engine any longer - Winter only lasted a week (so far) and the roads are good for driving.
(on that front - anyone in australia who knows roguepi from nissansilvia.com - could they go and give him a big kicking for me... 11 months and still no engine

The process was going quite well... until I dropped the bloody auto box on my foot... and then tried to struggle with the automatic conversion thingy that sits in the end of the crankshaft. NOTHING would move it - hydraulic method, pilot bearing pullers, slide hammer... not even a mm of movement. I learned a lot of new Russian words during the process
None of which I could mention in polite company.
Ran into two new problems after that:
1. the new driveshaft is the wrong one - so doesn't fit...
Now I am desperate for a spec S driveshaft if anyone has one PLEASE
2. the transmission mount crossmember is the wrong one - so tranny is just held in place with 2 bolts now.. If anyone could get me a part number for this I'd be really grateful as I'd like to order today from the office.
Apart from that - it was a great day and was nice to get started on the project again...
So... in summary - 3 requests:
1. cause some bodily harm the guy who didn't finish my engine
2. source a driveshaft
3. part number for manual transmission crossmember (spec S - 5 speed)
Cheers all....
...
(on that front - anyone in australia who knows roguepi from nissansilvia.com - could they go and give him a big kicking for me... 11 months and still no engine
The process was going quite well... until I dropped the bloody auto box on my foot... and then tried to struggle with the automatic conversion thingy that sits in the end of the crankshaft. NOTHING would move it - hydraulic method, pilot bearing pullers, slide hammer... not even a mm of movement. I learned a lot of new Russian words during the process
Ran into two new problems after that:
1. the new driveshaft is the wrong one - so doesn't fit...
2. the transmission mount crossmember is the wrong one - so tranny is just held in place with 2 bolts now.. If anyone could get me a part number for this I'd be really grateful as I'd like to order today from the office.
Apart from that - it was a great day and was nice to get started on the project again...
So... in summary - 3 requests:
1. cause some bodily harm the guy who didn't finish my engine
2. source a driveshaft
3. part number for manual transmission crossmember (spec S - 5 speed)
Cheers all....
...